6- Average speed display, average fuel consump-
tion display, momentary fuel consumption
display (Type 1)
7- Driving range display, momentary fuel con-
sumption display (Type 2)
8- Average fuel consumption display, momenta-
ry fuel consumption display (Type 2)
9- Average speed display, momentary fuel con-
sumption display (Type 2)
10- Function setting screen
11- Redisplay of a warning display screen
NOTE
l
While driving, even if you operate the multi-
information meter switch, the function set-
ting screen is not displayed. Always stop the
vehicle in a safe place before operating.
Refer to “Changing the function settings
(when the ignition switch or the operation
mode is ON)” on page 3-17.
l
When there is information to be announced,
such as a system fault, the buzzer sounds and
the screen display is switched.
Refer to “Interrupt display screen (when the
ignition switch or the operation mode is
ON)” on page 3-13.
Odometer/Tripmeter
E00524500207
Engine coolant temperature
display
E00521400566
This
indicates the engine coolant temper-
ature.
If the coolant becomes hot, “
” will
blink.
Pay careful attention to the engine cool-
ant temperature display while you are
driving.
CAUTION
l
If
the engine is overheating,
“
”
will blink. In this case, the
bar graph is on the red zone.
lmmediately park the vehicle in
a safe place and take the re-
quired measures. Refer to “En-
gine overheating” on page
6-04.
Driving range display
E00521500596
This displays the approximate driving range (how
many
more kilometres or miles you can drive).
When the driving range falls below approximately
50 km (30 miles), “---” is displayed.
Instruments and controls
3-10
3