EasyManuals Logo

Mitsubishi ASX User Manual

Mitsubishi ASX
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #170 background imageLoading...
Page #170 background image
NOTE
l
When
the engine is automatically stopped,
changes will occur in the driving operations.
Pay closel attention to the following.
The brake booster becomes inoperative
and the pedal effort will increase.
If the vehicle is moving, press down the
brake pedal harder than usual.
The electric power steering system (EPS)
becomes inoperative and it will become
harder to turn the steering wheel.
CAUTION
l
Observe
the following precautions when
the engine is stopped automatically. Oth-
erwise, an unexpected accident might oc-
cur when the engine restarts automatical-
ly.
Do not depress the accelerator pedal
to race the engine while the vehicle is
stopped (regardless of whether the en-
gine is running or stopped).
Otherwise, an unexpected accident
might occur when the engine restarts
automatically.
CAUTION
Do
not leave the driver’s seat or open
the bonnet.
If the driver’s seat belt is unfastened
or if the bonnet is opened, the
” dis-
play/indicator
will blink to notify the
driver. If this occurs, the engine will
not restart automatically even if the
clutch pedal is depressed, the seat belt
is refastened, and the bonnet is closed.
While depressing the brake pedal,
fully depress the clutch pedal and
turn the ignition switch to the
“START” position or press the engine
switch to start the engine.
For details, refer to “Starting and stop-
ping the engine” on page 1-15 or “Start-
ing” on page 4-13.
Do not move the gearshift lever to a po-
sition other than the “N” (Neutral) po-
sition.
If the gearshift lever is moved to a po-
sition other than the “N” (Neutral) po-
sition, the
display/indicator
blinks and the buzzer sounds.
If the gearshift lever is returned to the
“N” (Neutral) position, the display/in-
dicator stops blinking and the buzzer
stops sounding. The engine will not re-
start if the gearshift lever is in a posi-
tion other than the “N” (Neutral) posi-
tion.
NOTE
l
In
the following cases, the Auto Stop & Go
(AS&G) system will not operate and the en-
gine will not stop automatically even if the ve-
hicle is stopped.
Driver’s seat belt is not fastened
Bonnet is open
After the engine restarts automatically,
the vehicle speed has not exceeded ap-
proximately 5 km/h (3 mph)
Brake booster vacuum pressure is low be-
cause the brake pedal is depressed repeat-
edly or depressed harder than usual
After the ignition switch is turned from
the “ON” position to the “START” posi-
tion, approximately 30 seconds or more
have not elapsed.
After the engine restarts automatically
and the vehicle stops again within 10 sec-
onds.
After presing the engine switch to start
the engine from the operation mode is in
ON, approximately 30 seconds or more
have not elapsed
Engine coolant temperature is low
Ambient temperature is lower than ap-
proximately 3 °C
Air conditioning is operating and passen-
ger compartment has not sufficiently
cooled
Mode selection dial is set to the demister
position.
Refer to “Demisting of the windscreen
and door windows: For quick demisting”
on page 5-08.
When the air conditioning is operated in
AUTO mode where the temperature con-
trol dial is set to the max. hot or the max.
cool position (for vehicles with automatic
air conditioning).
Starting and driving
4-18
4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi ASX and is the answer not in the manual?

Mitsubishi ASX Specifications

General IconGeneral
BrandMitsubishi
ModelASX
CategoryAutomobile
LanguageEnglish

Related product manuals