Refer to “To resume the set speed” on page 4-46.
To deactivate
E00609701206
The set speed driving can be deactivated as follows:
l
Press
the “ON OFF” switch (A) (Cruise con-
trol will be turned off)
l
Press the “CANCEL” switch (D).
l
Depress the brake pedal.
The set speed driving is deactivated automatically
in any of the following ways.
l
When
you depress the clutch pedal (on vehi-
cles with M/T).
l
When your speed slows to about 15 km/h
(9 mph) or more below the set speed because
of a hill, etc.
l
When your speed slows to about 40 km/h
(25 mph) or less.
l
When the Active Stability Control (ASC)
starts operating. (if so equipped)
Refer to “Active stability control (ASC)” on
page 4-40.
CAUTION
l
On
vehicles equipped with CVT, al-
though the set speed driving will be deac-
tivated when shifting to the “N” (NEU-
TRAL) position, never move the selector
lever to the “N” (NEUTRAL) position
while driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactivated as
follows:
l
When
the engine speed rises and approaches
the tachometer's red zone (the red-coloured
part of the tachometer dial).
CAUTION
l
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the “ON-OFF” switch to turn off
the cruise control and have your vehicle
inspected by a MITSUBISHI MOTORS
Authorized Service Point.
To resume the set speed
E00609800617
If the set speed driving is deactivated by the condi-
tion
described in “To deactivate” on page 4-46,
you can resume the previously set speed by press-
ing the “ACC RES” switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however,
using
the switch does not allow you to resume the
previously set speed.
In these situations, repeat the speed setting proce-
dure:
l
The “ON OFF” switch is pressed.
Starting and driving
4-46
4
To Next Page
Loading...
Need help?
General
