3. When replacing the bulb on the right side of
the vehicle in the case of diesel-powered ve-
hicles, remove the clips (C) by prying with a
straight blade (or minus) screwdriver, and re-
move the side cover.
*: Front of the vehicle
4. Turn
the socket (D) anticlockwise to remove
it.
*: Front of the vehicle
5. Pull the bulb out of the socket.
6. To
install the bulb, perform the removal
steps in reverse.
Front turn-signal lamps
E01003800922
To remove
1.
Remove the upper cover.
For information regarding how to remove the
upper cover, refer to “Removing and instal-
ling the upper cover and duct” on page 8-08.
2. Remove
the entire socket and bulb assembly
(A) by turning it anticlockwise.
*: Front of the vehicle
3.
Remove the bulb by pulling it out.
To install
1. To
install the bulb, perform the removal
steps in reverse.
2. Install the upper cover.
For information regarding how to install the
upper cover, refer to “Removing and instal-
ling the upper cover and duct” on page 8-08.
Maintenance
8-28
8
To Next Page
Loading...
Need help?
General
