Side turn-signal lamps (on fender)*
E01003900516
NOTE
l
For
the side turn-signal lamps (on fender), it
is not possible to repair or replace just the bulb.
l
Contact a MITSUBISHI MOTORS Author-
ized Service Point when there is a need for re-
pair or replacement.
Side turn-signal lamps (on outside rear-
view mirror)*
E01003900529
NOTE
l
An
LED, not a bulb, is used in the side turn-
signal lamps (on outside rear-view mirror).
Contact a MITSUBISHI MOTORS Author-
ized Service Point when there is a need for re-
pair or replacement.
Front fog lamps*
E01004001524
1. Pull
the lamp cover (A) to the direction of
the arrow to remove it.
2. Remove the screws (B), and then remove the
lamp unit.
NOTE
l
Except
for vehicles equipped with daytime
running lamps, when unfastening the screws,
be careful not to move the beam position ad-
justment screw (C).
3. While holding down the tab (D), pull out the
socket (E).
4. Turn the bulb (F) anticlockwise to remove it.
5. To
install the bulb, perform the removal
steps in reverse.
Maintenance
8-29
8
To Next Page
Loading...
Need help?
General
