TV+Mitsubishi products that have A/V Network
terminals
The A/V Network is a special system that Mitsubishi developed to
make it easier to use the remote control. When the supplied cable
is connected between two Mitsubishi products with the A/V Net-
work, you can point the remote control at one product and it will
"pass" the remote control command to the other.
equipment you will need
• 1 A/V network cable
(included with the TV).
procedure
O Connect one end of an A/V network cable to the ACTIVE A/V
NETWORK terminal on the back of the TV.
Connect the other end of this cable to the A/V NETWORK IN
terminal on the back of a Mitsubishi component tihat has A/V
network terminals.
You can now point your componen_ remote (such as a VCR
remote) directly at the television. Tihe A/V cable will "pass" the
remote commands to the component.
_>Important:
The method of connecting the A/V network can change, depending
on which components you have and tile way you plan to use your
equipment. More detailed in]brmation is contained in the owner's
guide of each particular Mitsubishi component.
40 Chapter 2 : Connecting Your TV
To Next Page
Loading...
Need help?
General
