Using the remote control (cont.)
<setting up the remote control to operate your VCR>
O Turn off your VCR.
O Choose the layer using the select button on the remote control:
VCR-A, VCR-B or CABLE.
While holding in the POWER button on the remote control,
enter the code number listed in tile chart below for your brand of
VCR. Be sure to enter both di_pts of the code aumber. (If more
than one code number is listed, try the first one. If that code
does not work, try the next one until you find the correct code.)
Release the POWER button.
O Press the POWER button again. Your VCR s]hould turn on. If
the VCR turns on, your remote control is now set to operate your
VCR.
If your VCR does not turn on, repeat the instructions, trying each
code number listed for your brand of VCR.
Ifyour VCR
is this brand...
Mitsubishi (A)
Mitsubishi (B)
Canon
Emerson
Funai
General Electric
Goldstar
Hitachi
JVC
...enter this
code
01
02
O3
04, 05
06
03
07
O8
09
Ifyour VCR
is this brand...
Magnavox
Multitech
NEC
Panasonic
Philco
Philips
Quasar
RCA
Sanyo
...enterthis
code
03, 10,11
06
12
03
03, 10
03, 10, 11
O3
08, 13, 20
14
If your VC
is this bran
Scot
Sharp
Sony
Sy!jania
Syn_phonic
Teknika
Toshiba
Totevision
Zenith
...enterthis
code
15
16
17, 18
03, 10, 11
O6
04, 06
15
O7
19
46 Chapter 3 : Operating Your TV
To Next Page
Loading...
Need help?
General
