Using the remote control (cont.)
Important:
Important:
Important:
Sometimes manufacturers will change their products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cabLe box.
Each layer (CABLE, VCR-A or VCR-B) can be set for either a cable
box or a VCR.
When you replace the batteries in your remote control, the remote
will return to its initial setting.
<using your remote control[ to operate your VCR>
After you have set up your remote control: for your particular brand
of VCR, you can use the remote to operate your VCR.
O Choose the layer using the select switch on the remote control:
VCR-A, VCR-B or CABLE.
O Point the remote control at the VCR and press the ,desired
buttons.
If you are using a Mitsubishi VCR, you will be able to use all of the
buttons on the remote control to operate your VCR except for
MUTE, VOLUME and the PIP function but_;ons.
If you are using another brand of VCR: the buttons you can use are
POWER, CHANNEL, REC, STOP, PAUSE, REW, PLAY and FF.
Getting Started 47
To Next Page
Loading...
Need help?
General
