Need help?Do you have a question about the Mitsubishi DA-A10DC and is the answer not in the manual?
General| Type | Stereo Power Amplifier |
|---|---|
| Frequency Response | 5 Hz to 100 kHz |
| Total Harmonic Distortion (THD) | 0.008% |
| Input Sensitivity | 1 V |
| Signal-to-Noise Ratio | 120 dB |
| Damping Factor | 100 |
| Output | Speaker terminals |
| Output Power | 100 W per channel into 8Ω (stereo) |
| Speaker load impedance | 4Ω to 16Ω |
Details components and functions of the amplifier's front panel.
Steps to remove the bottom cover and its screws.
Instructions for removing the main circuit board and its connections.
Procedure for safely removing electrolytic capacitors from the unit.
Procedure for setting the amplifier's idling current to specifications.
Procedure for setting the neutral-point potential of the amplifier.
To Next Page
