Mitsubishi Engine cooling - Water Pump; Water Pump <4 G6> Removal and Installation

ENGINE COOLING -
Water Pump <4G6>
14-15
WATER PUMP <4G6>
14100270363
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D Engine Coolant Draining and Supplying
(Refer to P.14-10.)
D Timing Belt Tensioner Pulley Removal and
Installation (Refer to GROUP 11.)
12 - 15 Nm
24 Nm
8 ´ 60 8 ´ 22
8 ´ 14
20 - 25 Nm
Bolt specifications
8 ´ 25
8 ´ 22
Screw diameter ´ length mm
1
2
4
3
2
Removal steps
1. Alternator brace
2. Water pump
3. Water pump gasket
"
A
A
4. O-ring
INSTALLATION SERVICE POINT
"
A
A
O-RING INSTALLATION
Insert the O-ring to the water inlet pipe assembly, and coat
the outer circumference of the O-ring with water or engine
coolant.
Caution
Do not allow engine oil or other greases to adhere to
the O-ring
Water pump
O-ring
Water inlet pipe assembly