Mitsubishi FDC121KXZEN1-W - Page 124

-
122
-
'20 • KX-T-373
When taking the wiring out from the upper center, open a hole before separating the upper and bottom cases. This will reduce risk of
damaging the PCB and facilitate subsequent work.
When taking the wiring out from the upper left, take care not to damage the PCB and not to leave any chips of cut thin wall inside.
8
50
200
パテでシール
すること
リモコン配線
下ケース配線穴
ブッシング
Wiring hole on
bottom case
③
C/R .tinu roodni fo slanimret Y dna X ot C/R fo slanimret Y dna X morf seriw tcennoC
wires (X, Y) have no polarity. Fix wires such that the wires will run around the terminal
screws on the top case of R/C.
④
Install the upper case with care not to pinch wires of R/C.
Cautions for wire connection
Use wires of no larger than 0.5mm
2
for wiring running
through the remote control case. Take care not to pinch
the sheath.
T
If the wire is connected using an electric driver, it may
cause failure or deformation.
In case of exposing wiring
(When the wiring is taken out from the “upper center” or
“upper left” of R/C)
①
Cut out the thin wall sections on the cases for the size of wire.
②
screws.
③
eht dniheb gniriw eht ssap ,retnec reppu eht fo esac nI
bottom case. (Hatched section)
④
Y dna X ot C/R fo slanimret Y dna X morf seriw tcennoC
terminals of indoor unit. R/C wires (X, Y) have no polarity.
Fix wires such that the wires will run around the terminal
screws on the top case of R/C.
⑤
.C/R fo seriw hcnip ot ton erac htiw esac pot eht llatsnI
⑥
ni tuc aera eht laeS
①
with putty.
上面中央の場合
上面左の場合
上ケース
下ケース
120mm
左側の場合
190mm
中央の場合
8
上面中央の場合
上面左の場合
上ケース
下ケース
Upper center
Upper left
Bottom case
Upper case
120mm
(for retrieving wire
from upper left)
190mm
(for retrieving
wire from upper
center)
PJZ012A171_EN.indd 7 2018/05/09 14:37:07