GT1020/GT1030-to-FR-E 700 Inverter
Overview:
This document provides a simple guide to setting up the GT1020 or GT1030
Graphic Operation Terminal (GOT) hardware and firmware for use with an
FR-E 700 Inverter.
Hardware Introduction:
The GT1020 and GT1030 are monochrome, 3-color backlight, two
communication channel GOT1000 Series touch panel interfaces used for
capturing user input to a system.
It should be noted that not all products from the GT1020 or GT1030 range are
compatible with a FREQROL inverter connection. Compatible products are
identified in the table below:
Model Size Extension Backlight Colors Comm. IF Power
LBD Green/Orange/Red RS-422
GT1020
3.7”
160 x 64 dot
LBDW White/Pink/Red RS-422
24V DC
LBD Green/Orange/Red RS-422
GT1030
4.5”
288 x 96 dot
LBDW White/Pink/Red RS-422
24V DC
For new GT1020 and GT1030 units, included in the box should be the
GT1020/GT1030 (A), 1 PLC Communication Connector (B), 1 rubber Panel
Mounting Packing (C), and 4 Panel Mounting Brackets (D).
Cabling:
Power
The applicable GT1020/GT1030 GOTs, require an external
24V DC power supply to be connected to the Power Terminal
on the back of the GOT.
A
B
C
D
To Next Page
Loading...
