What to do if the CPU No. is not between 0 and 2 on Mitsubishi Touch terminals?
If the CPU No. is set to a number other than '0' to '2' on your Mitsubishi Touch terminals, a communication error will occur, preventing monitoring. Ensure the CPU No. is set to '0', '1', or '2' to resolve this issue.
General| Power Supply | 24VDC |
|---|---|
| Software | GT Works3 |
| Processor | RISC CPU |
| Interface | Ethernet, USB, RS-232, RS-422/485 |
| Operating Temperature | 0°C to 50°C |
| Display Type | TFT LCD |
| Storage Temperature | -20°C to 60°C |
| Humidity | 10% to 90% (non-condensing) |
| Shock Resistance | 147 m/s² (15G), 11ms duration |
| Touch Panel | Analog Resistive |
Describes precautions related to the product's design and potential failures.
Details safety measures during installation and removal of the GOT unit.
Outlines critical safety instructions for electrical wiring procedures.
Provides safety guidelines for performing test operations on the GOT.
Describes methods for executing GOT utility functions and installing BootOS.
Configuration of IP address, subnet mask, and default gateway settings.
Setting authorization for SoftGOT-GOT link function.
Settings for storage location and procedures for backup and restoration.
Configuration options for multimedia functions, including video and audio.
Function to collect system data for diagnosis and display results.
Checking and changing Ethernet communication settings, including host.
Configuration options for the GOT's display behavior and screen settings.
To Next Page
