19.1 BootOS and Basic System Application to be Installed
19 - 1
19
INSTALLATION OF BOOTOS AND BASIC SYSTEM APPLICATION
19. INSTALLATION OF BOOTOS AND BASIC SYSTEM APPLICATION
To execute the GOT utility, install the BootOS and system applications on the C drive (built-in flash memory) of the GOT, or
set the boot drive of the package data to [A:SD card] and insert an SD card with the package data into the GOT.
(BootOS is installed in the GOT at factory shipment. It is not necessary to install BootOS when upgrading of it is
unnecessary.)
This chapter explains the installation using GOT.
Refer to the following for the installation which uses GT Designer3.
âž GT Designer3 (GOT2000) Help
19.1 BootOS and Basic System Application to be Installed
Under-mentioned BootOS and basic system application are necessary to execute utility.
System application name Function overview
BootOS
Required for the control of GOT and the communication between PC and GOT.
Installed at factory shipment.
(BootOS can also be installed from GT Designer3. When BootOS is installed, the GOT is initialized
and goes to the status at factory shipment. When BootOS needs to be reinstalled, the basic system
application has to be installed in the GOT.)
System application
Required for the GOT operation as the monitoring function of GOT, installation and deletion of the
system application or project data, touch key control or display function of the screen and guidance.
Required for display and operation of the user-created screen and utility screen.
Not installed in GOT at factory shipment.
Install it from GT Designer3 or an SD card.
The GOT can be started with
no need to install package data.
Install an SD card
to the GOT.
Set the OS boot drive to
[A: Standard SD card].
Install an SD card
to the GOT.
SD card
Install package data from a GOT
to another GOT using an SD card.
SD card
Installing
package data
GOT
GT Designer3 → SD card/ → GOT
GOT → SD card/ → GOT
Writing
package data
Uploading
package data
GT Designer3
GOT
GOT