6 - 94
6.11 Memory Check
6.11.3 Memory check operation
Carries out write/read check of memory.
When drive is not displayed
When the drive (memory) to check is not displayed, confirm the mounting procedure or memory
type with reference to the following.
➠ GOT2000 Series User's Manual (Hardware)
When no faults are found in mounting, etc, a memory failure may be arosen.
Replace the data storage or built-in flash memory (C drive).
For details of built-in flash memory, contact your local Mitsubishi (Electric System) Service.
The following example explains about Memory Check using built-in flash memory (C drive).
For the Built-in SD card (A drive) memory check, install the SD card before carrying out the same key operations as those
for the built-in flash memory check. For the USB drive (B drive, E drive, F drive, or G drive) memory check, install the USB
memory before carrying out the check operations.
1. Select [Flash Memory] in the Memory check setting screen.
If select the [OK] button, the numeric keyboard window is
displayed.
If select [Cancel] button, returns to the initial menu.
2. Touch to input password ([5] [9] [2] [0]) and touch the
[Enter] key.
If touch the [Enter] key,executes read/write check for the
built-in flash memory, which is completed in around 10
seconds.
To Next Page
Loading...
Need help?
General
