Mitsubishi GOT2000 Series User Manual

3.3 Sequence Program Monitor
3 - 7
3
SPECIAL FUNCTION SETTING
3.3 Sequence Program Monitor
3.3.1 Sequence program monitor setting
Storage locations and others for data to be used for the sequence program monitor function can be set.
Storing a sequence program eliminates the need for reading the program from the PLC CPU at the next GOT startup. This
shortens the time required for the execution of the sequence program monitor.
For the details of the sequence program monitor, refer to the following.
➠ GOT2000 Series User's Manual (Monitor)
■1. Sequence program to be saved
The sequence program to be saved is used by the GOT to execute the sequence program monitor.
The sequence program can be saved in the SD card with this function, however it cannot be copied in the personal
computer to be referred/edited with GX Developer, etc.
Function Description Setting range
Data save location Select the storage location for the sequence program monitor.
A: Built-in SD card
B: USB Drive
E: USB Drive
F: USB Drive
G: USB Drive
<Default: A: Built-in SD card>
Automatic program
read
Select whether to automatically read sequence programs when the
sequence program monitor starts from a touch switch or alarm display.
YES/NO
<Default: YES>
Priority comment
If both Common comment and Each program comment are set for the same
device in a sequence program, select either of the comments to be displayed
in the sequence program monitor.
Common comment/Each program comment
<Default: Common comment>

Mitsubishi GOT2000 Series Specifications

General

Brand	Mitsubishi
Model	GOT2000 Series
Category	Control Panel
Language	English