6.9 SRAM management
6 - 87
6
DATA CONTROL
6.9.4 SRAM management operation
■1. Operation to initialize all or selected areas of the SRAM user area
Step 1. Perform any of the following operations.
•To initialize all areas of the SRAM user
area, touch the [Initialize all] button.
•To initialize selected areas of the
SRAM user area, select the check box
of the area to be initialized, and then
touch the [Initialize selected area]
button.
Step 2. The dialog box shown left appears.
Check the description of the dialog box.
To initialize the SRAM user area, touch
the [OK] button.
To cancel the initialization, touch the
[Cancel] button.
(Example: Dialog box if the [Initialize all] button is touched)
Step 3. When touching the [OK] button in step2,
the dialog box shown left appears for
recheck.
To start the initialization, touch the [OK]
button.
To cancel the initialization, touch the
[Cancel] button.
Step 4. The completion dialog box appears
when the initialization is completed.
To close the dialog box and restart the
GOT, touch the [OK] button.
To Next Page
Loading...
Need help?
General
