7.2 Prior Preparations for Installing BootOS and System Application
7 - 3
7
INSTALLATION OF BOOTOS AND BASIC SYSTEM APPLICATION
7.2 Prior Preparations for Installing BootOS and System Application
For the installation using GOT, the data storage that is storing BootOS or the system application is required.
There are the following three methods for the installation of BootOS and system application.
(1) [To Memory Card] from GT Designer3
➠
GT Designer3 (GOT2000) Help
(2) Uploading from other GOT (BootOS or system application has been installed)
➠
6. DATA CONTROL
(3) Using an SD card that stores data with OS boot drive set to A drive
➠
GT Designer3 (GOT2000) Help
POINT
POINT
Precautions on writing BootOS, system applications in a data storage
When writing BootOS, system applications or others into the data storage, be sure to execute by
the utility of other GOT or GT Designer3.
The installation is not executed properly with the storage to which uploaded from the utility of
GOT or copied by software other than GT Designer3.
Note the available capacity of the data storage.
The available capacity of BootOS and system applications can be confirmed by [Write to Memory
Card] or [Write Option] of GT Designer3.
[Communicate with Memory Card] dialog
[Write Option] dialog
Available space of the system application
Available space of the data storage
To Next Page
Loading...
Need help?
General
