5
Note: This document is for reference only. For detailed settings and safety information refer to the respective product manual.
GOT Terminals
The GT1020/GT1030 is fitted with screw terminals, use a small flathead
screwdriver to secure the wires within the PLC Communication Connector.
Terminal points are illustrated below:
Programming Cables:
The GT1020 and GT1030 come pre-installed with an OS and FX
communication driver, but without any project data. To download a project
from a PC running GT Designer2 to the GOT, a programming cable is
required that connects to the RS-232C 6-pin Mini-DIN port on the back of the
GOT. It is recommended to use a shielded USB A-type to Mini-B type cable
with a ferrite core paired with the GT10-RS2TUSB-5S, but any RS-232C
programming cable for the Q-Series will also work fine. A diagram of both is
shown below.
Note that using the GT10-RS2TUSB-5S will require a virtual USB COM port
driver to be installed on the PC. The COM port number can be automatically
or manually assigned so that it does not overlap with the existing COM port
numbers assigned on that PC. When using a Q-Series programming cable,
the COM port number already assigned to the RS-232C interface of the PC
will have to be checked.
QC30R2 (RS-232C)
OR
USB + GT10-RS2TUSB-5S
PC
GOT
To Next Page
Loading...
