Features and controls
3-55
3
Rear-view camera
(if so equipped)
N00546200131
When the selector lever is in the “R” (REVERSE) position
with the electric motor switch is in the “ON” position, the rear-
view image will be displayed on the screen of the Mitsubishi
Multi Communication System.
When the selector lever is shifted out of the “R” position, the
rear-view image will turn off.
Location of rear-view camera
The rear-view camera is in the liftgate.
WARNING
!
● Never rely solely on the rear-view camera to clear
the area behind your vehicle. Always check visually
behind and all around your vehicle for persons, ani-
mals, obstructions or other vehicles. Failure to do so
can result in vehicle damage, serious injury or
death.
● The rear-view camera is an aid system for backing
up, but it is not a substitute for your visual confir-
mation.
● The view on the screen is limited, and objects out-
side the view, such as under the bumper or around
either corner of the bumper end, cannot be seen on
the screen.
CAUTION
!
● If the camera lens gets dirty, a clear image cannot be
obtained. As necessary, rinse the lens with clean
water and gently wipe with a clean, soft cloth.
● To avoid damaging the camera;
• Do not rub the cover excessively or polish it by
using an abrasive compound.
• Do not disassemble the camera.
• Do not splash hot water directly on the lens.
• Do not spray the camera and its surroundings with
high-pressure water.
• Make sure that the liftgate is securely closed when
backing up.
BK0140800US.book 55 ページ ２０１１年９月２９日 木曜日 午後３時２８分
To Next Page
Loading...
