6-12
For emergencies
6
7. Take the cap (C) off the tire sealant bottle (D). Do not
remove the seal (E). Screw the filler hose (F) onto the bot-
tle (D). As you screw the filler hose onto the bottle, the
seal will break, allowing the sealant to be used.
8. Take the valve cap (G) off the tire valve (H), then press
the valve remover (I) onto the valve as illustrated. Allow
all of the air in the tire to escape.
CAUTION
!
● If you shake the bottle after screwing on the hose,
sealant may spray out of the hose.
BK0140800US.book 12 ページ ２０１１年９月２９日 木曜日 午後３時２８分
To Next Page
Loading...
