Mitsubishi LT2-2230 - Page 14

OPERATION
• Position adjustment of needle point
Adjust needle position so that gap between the
upperedgeof needleeye and the hookpointis(§)
mmwhen the needle Is lifted by@ mm from Its
lowest position shown Inbefore page.
(1) Remove the face plate, loosen the set screw
of needle bar bracket and vertically move the
bar to adjust.
(2) After the adjustment, tighten the set screw.
—11 —
0
-Needle bar
-Needle bar
bracket
Set screw
From the library of: Superior Sewing Machine & Supply LLC