60
OPERATING PROCEDURE PHOTOS
3. Removing the outdoor fan motor
(1) Remove the cabinet. (Refer to 1)
(2) Unconnect the connector remove the clamp of fan motor
lead wire.
(3) Remove the propeller nut and remove the propeller.
(4) Remove screws fixing the fan motor.
4. Removing the compressor
(1) Remove the cabinet. (Refer to 1)
(2) Remove the soundproof felt.
(3) Remove the terminal cover on the compressor
(4) Remove the electrical assembly.
(Refer to 2)
(5) Release gas from the refrigerant circuit.
(6) Disconnect the welded part of the discharge pipe
(7) Disconnect the welded part of the suction pipe.
(8) Remove nuts fixing the compressor.
(9) Remove the compressor.
Photo 5
Terminal cover
Compressor
Discharge
pipe
Suction
pipe
Compressor nuts
Photo 4
propeller fan
Set screws for
outdoor fan motor
Lead clamps
Outdoor
fan motor
Propeller
fan nut
Set screws for
outdoor fan motor
OB267--2.qxp 01.4.13 1:01 PM Page 60
To Next Page
Loading...
