Continuously variable transmission (CVT) (if so equipped)
5-42 Features and controls
This position is used for most city and high-
way driving. The transmission will automati-
cally and continuously change its gear ratio
depending on road and driving conditions.
Use when engine braking is needed, or for
high-power sport drive.
This position is for driving up very steep hills
and for engine braking at low speeds when
driving down steep hills.
N00549500018
N00574601036
When the selector lever position indicator
blinks while you are driving, there could be a
malfunction in the automatic transaxle system
or CVT fluid temperature becomes abnor-
mally high.
Never move the selector lever to the “N”
(NEUTRAL) position while driving since
you could accidentally slip it into the “P”
(PARK) or “R” (REVERSE) position,
damaging the transmission.
To prevent the vehicle from rolling when
stopped on a slope, the engine should be
started in the “P” (PARK) position, not in
“N” (NEUTRAL) position.
To prevent rolling, always keep your foot
on the brake pedal when the vehicle is in
“N” (NEUTRAL) position, or when shift-
ing into or out of “N” (NEUTRAL) posi-
tion.
“D” DRIVE
To prevent transmission damage, never shift
into the “D” (DRIVE) position from the “R”
(REVERSE) position while the vehicle is in
motion.
“Ds” DOWNSHIFT & SPORTY
DRIVING
“L” LOW
This position can be used for maximum
engine braking.
Be very careful not to shift into “L”
(LOW) suddenly.
Sudden engine braking may cause the
tires to skid.
Select this position according to the road
conditions and vehicle speed.
When a malfunction occurs in
the automatic transaxle
When the selector lever position
indicator blinks
The “A” indicator blinks only if the CVT
selector lever switch is broken.
It is not seen during normal driving.
BK0235100US.book 42 ページ ２０１５年１１月２０日 金曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
