Mitsubishi Mirage 2017 User Manual

Continuously variable transmission (CVT) (if so equipped)
Features and controls 5-41
5
If you need to move the vehicle, shift the
selector lever as follows.
1. Make sure the parking brake is fully
applied.
2. Stop the engine if it is running.
3. Insert a screwdriver with a cloth over its
tip into the notch (A) of the cover. Pry
gently as shown to remove the cover.
4. Depress the brake pedal with the right
foot.
5. Insert a screwdriver in the shift-lock
release hole (B). Shift the selector lever to
the “N” (NEUTRAL) position while
pressing the screwdriver down.
N00560400078
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the selector lever position is shown on
the multi-information display.
N00560601093
This position locks the transmission to pre-
vent the vehicle from moving. The engine can
be started from the “P” (PARK) position.
Move the lever to this position only after the
vehicle has come to a complete stop.
At this position, the transmission is disen-
gaged. It is the same as the neutral position on
a manual transaxle and should be used when
the vehicle is not moving for an extended
length of time during driving, such as in a
traffic jam.
Selector lever position display
Selector lever positions
“P” PARK
“R” REVERSE
CAUTION
 Never shift into the “P” (PARK) or “R”
(REVERSE) position while the vehicle is in
motion. If the lever is shifted into the “P”
(PARK) or “R” (REVERSE) position while
the vehicle is in motion, the transmission
may be damaged.
“N” NEUTRAL
BK0235100US.book 41 ページ ２０１５年１１月２０日 金曜日 午後３時１２分

Mitsubishi Mirage 2017 Specifications

General

Brand	Mitsubishi
Model	Mirage 2017
Category	Automobile
Language	English