Active stability control (ASC)
Features and controls 5-51
deactivate the system by pressing down the
“ASC OFF” switch for 3 seconds or longer.
When the ASC is deactivated, the indica-
tor will turn on. To reactivate the ASC,
momentarily press the “ASC OFF” switch;
the indicator is turned off.
N00546500118
N00546600119
If an abnormal condition occurs in the sys-
tem, the following indicator will turn on.
For safety reasons, the “ASC OFF” switch
should be operated when your vehicle is
stopped.
Be sure to keep the ASC on while driving in
normal circumstances.
Using the “ASC OFF” switch turns off both
the stability control function and the traction
control function.
When moving out of mud, sand or fresh
snow, pressing the accelerator pedal may not
allow the engine speed to increase. In such
situations, temporarily turning off ASC with
the “ASC OFF” switch will make it easier to
move out your vehicle.
If you continue to press the “ASC OFF”
switch after the ASC is turned off, the “mis-
taken operation protection function” will
activate and the ASC will turn back on.
ASC operation indicator or
ASC OFF indicator
-
ASC operation indicator
The indicator will blink when the
ASC is operating.
-
ASC OFF indicator
This indicator will turn on when the
ASC is turned off with the “ASC
OFF” switch.
When indicator blinks, ASC is operating,
which means that the road is slippery or that
your vehicle’s wheels are beginning to slip.
If this happens, drive slower with less accel-
erator input.
The indicator may turn on when you start
the engine. This means that the battery volt-
age momentarily dropped when the engine
was started. It does not indicate a malfunc-
tion, provided that the display goes out
immediately.
When a compact spare tire has been put on
your vehicle, the gripping ability of the tire
will be lower, making it more likely that the
indicator will blink.
ASC warning indicator
-
ASC indicator
-
ASC OFF indicator
BK0235100US.book 51 ページ ２０１５年１１月２０日 金曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
