3. With this indicator flashing, if you lightly
press the multi-information meter switch,
the display switches from “---” to
“cLEAr”. After that, the time until the
next periodic inspection is shown.
N00556801267
The “Average fuel consumption reset mode”,
“Fuel consumption unit” and “Temperature
unit” setting can be modified as desired,
when the ignition switch or the operation
mode is ON.
N00575501032
You can change the mode condition for the
average fuel consumption display to “Auto
reset” or “Manual reset”.
1. When you lightly press the multi-informa-
tion display switch a few times, the infor-
mation display switches to the driving
range display.
Refer to “Information display” on page
5-62.
2. Each time you press the multi-information
display switch for 1 second or more on
driving range display, you can switch
reset mode for average fuel consumption.
(A: Auto reset mode, B: Manual reset
mode)
When the average fuel consumption is
being displayed, if you hold down the
multi-information display switch, these
calculations will be reset to zero.
When the following operation is per-
formed, the mode setting changes auto-
matically from manual to auto.
The customer is responsible for making sure
that regular inspections and maintenance and
periodic inspections and maintenance are
performed.
Inspections and maintenance must be per-
formed to prevent accidents and malfunc-
tions.
The “---” display cannot be reset while the
ignition switch or the operation mode is in
ON.
When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next
periodic inspection is displayed.
If you accidentally reset the display, consult
an authorized Mitsubishi Motors dealer for
assistance.
Changing the function settings
To Next Page
Loading...
Need help?
General
