Turn the temperature control dial clockwise
or counterclockwise to the desired tempera-
ture. Select the desired blower speed to fit
your needs.
N00738401045
Set the mode selection dial to the positions
shown in the illustration and set the air selec-
tion lever to the outside air position.
The air flow will be directed to the leg area
and the upper part of the passenger compart-
ment. Set the desired blower speed.
Warm air flows to the leg area and unheated
or slightly warm air (depending upon the
position of the temperature control dial) flows
to the upper part of the passenger compart-
ment.
N00738501091
Set the mode selection dial (between “ ”
and “ ”) to remove frost or mist from the
windshield and door window.
For ordinary defrosting
Use this setting to keep the windshield and
door windows clear of mist, and to keep the
leg area heated (when driving in rain or
snow).
1. Set the mode selection dial to the “ ”
position.
The engine speed may increase when the
heating is operating.
Since creeping will occur strongly if the
engine speed becomes high while the vehicle
with a CVT is stationary, fully depress the
brake pedal to prevent the vehicle from
creeping.
For quick heating, set the blower speed at the
3rd position.
Combination of unheated air and
heated air
Defrosting or defogging (wind-
shield, door windows)
For safety, make sure you have a clear view
through all the windows.
BK0235100US.book 6 ページ ２０１５年１１月２０日 金曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
