N00562000065
Your F.A.S.T.-key operates on a radio fre-
quency subject to Federal Communications
Commission (FCC) Rules (For vehicles sold
in U.S.A.) and Industry Canada Rules (For
vehicles sold in Canada). This device com-
plies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
This device may not cause harmful inter-
ference.
This device must accept any interference
received, including interference that may
cause undesired operation of this device.
N00562100066
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
2. With the Mitsubishi mark facing you,
insert the cloth-cov-ered tip of a flat blade
screwdriver into the notch in the case and
use it to open the case.
3. Remove the old battery.
4. Install a new battery with the + side (A)
up.
• The doors and the liftgate cannot be locked
or unlocked.
• The panic alarm cannot be operated.
• The indicator light (4) is dim or does not
come on.
If you lose your F.A.S.T.-key, please contact
an authorized Mitsubishi Motors dealer for a
replacement.
If you wish to obtain an additional F.A.S.T.-
key, please contact an authorized Mitsubishi
Motors dealer. A maximum of four F.A.S.T.-
key can be programmed for your vehicle.
To use the new remote control transmitters, it
is necessary to register the key with the elec-
tronic immobilizer and keyless entry system.
Refer to “Electronic immobilizer (Anti-theft
starting system): Customer F.A.S.T.-key pro-
gramming” on page 5-20.
General information
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
Procedure for replacing the
remote control transmitter bat-
tery
To Next Page
Loading...
