A - 6
(7) General instruction
To illustrate details, the equipment in the diagrams of this Instruction Manual may have been drawn
without covers and safety guards. When the equipment is operated, the covers and safety guards must
be installed as specified. Operation must be performed in accordance with this Instruction Manual.
DISPOSAL OF WASTE
Please dispose a servo amplifier and other options according to your local laws and regulations.
EEP-ROM life
The number of write times to the EEP-ROM, which stores parameter settings, etc., is limited to 100,000. If
the total number of the following operations exceeds 100,000, the servo amplifier may malfunction when the
EEP-ROM reaches the end of its useful life.
Write to the EEP-ROM due to parameter setting changes
Write to the EEP-ROM due to device changes
Compliance with global standards
Refer to appendix 2 for the compliance with global standard.
Using HF-KN series and HF-SN series servo motors
For the combinations and characteristics when using HF-KN series and HF-SN series servo motors, refer to
appendix 5.
«About the manual»
You must have this Instruction Manual and the following manuals to use this servo. Ensure to prepare
them to use the servo safely.
Relevant manuals
Manual name Manual No.
MELSERVO-JE Servo Amplifier Instruction Manual (Troubleshooting) SH(NA)030166
MELSERVO-JE-_A Servo Amplifier Instruction Manual (Positioning Mode) SH(NA)030150
MELSERVO-JE-_A Servo Amplifier Instruction Manual (Modbus-RTU Protocol) SH(NA)030177
MELSERVO HG-KN/HG-SN Servo Motor Instruction Manual SH(NA)030135
EMC Installation Guidelines IB(NA)67310
«Cables used for wiring»
Wires mentioned in this Instruction Manual are selected based on the ambient temperature of 40 ËšC.
To Next Page
Loading...
Need help?
General
