ON_FF
Press the _ button.
Select the operation mode by pressing the
button.
Each time this button is pressed, the operation mode
is changed in sequence: f_ (I FEEL,,.) -_ _ (COOL)
6 (DRY) _ _ (FAN)
To stop operation:
m
Oh_3FF
Press the Q button.
After the operation mode is set once, the operation
starts in the mode set previously from the next time
by simply pressing the _ button.
®
When the set temperature is to be changed:
,,,%
• Press the _ button to lower the temperature, One
press lowers the temperature by about 2 °F.
• Press the _ button to raise the temperature. One
press raises the temperature by about 2 °F,
• The temperature control (temperature setting) can-
not be done.
• The room temperature is slightly lowered in this op-
eration mode.
The details of the display on the indoor unit
are explained on page 7.
I NOTE
When the ambient temperature is too high, the room tem-
perature may not reach the set temperature since the unit
operates to cool under high load.
8
To Next Page
Loading...
