12
HOMELINK
®
(IF EQUIPPED)
PROGRAMMING A NEW HOMELINK
®
To program HomeLink
®
to operate a garage door, gate, or entry door opener, home
or office lighting, you need to be at the same location as the device.
1. Press the HomeLink
®
button that you would like to program. The indicator
light (A) will flash orange slowly.
2. Position the end of your hand-held transmitter (B) 1 to 3 inches away from the
HomeLink
®
button while keeping the indicator light in view.
3. Press and hold the hand-held transmitter button while watching the indicator
light (A). Continue pressing the button until the indicator light (A) changes
from slowly flashing orange to either rapidly flashing green (rolling code)
or continuously lit green (fixed code). Now you may release the hand-held
transmitter button.
4. Press the just-trained HomeLink
®
button and observe the indicator light.
• If the indicator light stays on constantly green, programming is complete
and your device should operate when the HomeLink
®
button is pressed
and released.
• If the indicator light rapidly flashes green, firmly press, hold for 2
seconds and release the programmed HomeLink
®
button. Repeat the
“press/hold/release” sequence a second time, and, depending on the
brand of the garage door opener (or other rolling code equipped device),
repeat this sequence a third time to complete the programming process.
At this point if your device operates, programming is complete.
• If the device does not operate, continue with “Programming a new
HomeLink
®
” steps 5 to 7 to complete the programming of a rolling code
equipped device.
1 - HomeLink
®
button 1
2 - HomeLink
®
button 2
3 - HomeLink
®
button 3
To Next Page
Loading...
