Mitsubishi PUMY-P100YHM - Page 65

65
Outdoor noise filter circuit board
PUMY-P100YHMA PUMY-P100YHMA-BS
PUMY-P125YHMA PUMY-P125YHMA-BS
PUMY-P140YHMA PUMY-P140YHMA-BS
LI1, LI2, LI3, NI
POWER SUPPLY
LI1-LI2/LI2-LI3/LI3-LI1 : AC380/400/415V input
LI1-NI/LI2-NI/LI3-NI : AC220/230/240V input
(Connect to the terminal block (TB1))
GD1
Connect to the earth
CNAC2
AC220/230/240V
(Connect to the
outdoor controller
circuit board (CNAC))
CNDC
(Connect to the
outdoor controller
circuit board (CNDC))
LO1, LO2, LO3
POWER SUPPLY
LO1-LO2/LO2-LO3/LO3-LO1 : AC380/400/415V OUTPUT
(Connect to the outdoor converter circuit board and ACL(L1-IN, ACL2, ACL3))
CNCT
Primary current
(Connect to the
outdoor power
circuit board (CN5))
NO
Connect to the
outdoor converter
circuit board.(N-IN)
CNL
Connect to the ACL4
CNAC1
AC220/230/240V
(Connect to the outdoor transmission power
board(CN1))
GD3
Connect to the earth
w The noise filter circuit board of PUMY-P·YHMA
has been changed from support type to lead wire
type(GD3).
This circuit board can be applied to PUMY-P·YHM(1))
(Convertible).