Mitsubishi Q00JCPU - Page 847

APPENDICES
Appendix 2 Special Register List
App - 58
9
Parameters
10
Device Explanation
11
CPU Module Processing Time
12
Procedure for Writing Program to CPU ModuleAppendicesIndex
(5) Drive information
*1: When the Q2MEM-8MBA is used, value stored in the special register SD603 differs depending on the combination of the serial number of the High
Performance model QCPU and the manufacture control number of the ATA card.
For details, refer to QCPU User's Manual (Hardware Design, Maintenance and Inspection).
TableApp.24 Special register
Number Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
D9
Corresponding
CPU
SD600
Memory card
typs
Memory card typs
• Indicates the type of the memory card installed.
S (Initial and
card removal)
New
Qn(H)
QnPH
QnPRH
QnU
Memory card A
typs
Memory card A
typs
• Indicates the type of memory card A installed.
S (Initial and
card removal)
New QnA
SD602
Drive 1
(Memory card
RAM) capacity
Drive 1 capacity
• Drive 1 capacity is stored in 1 k byte units.
• (Empty capacity after format is stored.)
S (Initial and
card removal)
New
QnA
Qn(H)
QnPH
QnPRH
QnU
SD603
Drive 2
(Memory card
ROM) capacity
Drive 2 capacity
• Drive 2 capacity is stored in 1 k byte units.
*1
• (Empty capacity after format is stored.)
S (Initial and
card removal)
New
Qn(H)
QnPH
QnPRH
QnU
• Drive 2 capacity is stored in 1 k byte units.
S (Initial and
card removal)
New QnA
b4
b3 b0
0
0: Does not exist
(1: SRAM)
b8 b7b15
to to to
Drive 1
(RAM) type
Drive 2 type
0: Does not exist
1: SRAM card
2: ATA card
3: Flash card
b4 b3 b0
0
b8 b7b15
Drive 1
Drive 2
0: Does not exist
0: Does not exist
1: SRAM(RAM) type
(ROM) type
2: E PROM
3: Flash ROM
2
to to to