– 9 –
1
2
COOL/HEAT/DRY/FAN mode operation procedure
Air flow direction adjustment procedure. Page 10
Program changing procedure
Set the new program.
• The operation program can also be set or changed when
the air-conditioner is not in operation.
Aim the remote control at the air-conditioner.
Press the ON/OFF button.
Press the MODE select button.
Move the [ mark] to the desirable operation position.
HE type:
(Cool), (Heat), (Dry)
CE type:
(Cool), (Fan), (Dry)
Press the TEMP button.
Press or button for the desired temperature.
Standard
Press the FAN SPEED button
Set the air flow rate as desired.
4
3
COOL
DRY
HEAT
26°C~28°C21°C~24°C
FAN
22°C~24°C
To stop: Press the ON/OFF button.
•
The air is not blown out during the operation.
Page 17
NOTE
Concerning HIGH POWER operation
Pressing the HI POWER button intensifies the operating power and initiates a powerful cooling or heating operation for 15 minutes continuously.
The remote controller illuminates but the wind capacity display is erased.
Concerning ECONOMY operation
Pressing the ECONO button initiates a soft operation with the power suppressed in order to avoid an excessive cooling or heating. The unit operates
1.5°C higher than the setting temperature for the weak wind capacity during cooling or 2.5°C lower than that during heating. A message is
displayed on the remote controller. The wind capacity display is erased.
NOTE
NOTE
• During the HIGH POWER operation, the room temperature is not
controlled. When it causes an excessive cooling or heating, press
the HI POWER button once more to cancel the HIGH POWER
operation.
• HIGH POWER operation is not available during the dehumidify-
ing operation.
• During ON timer operation, HIGH POWER operation will start
when the ON time is reached.
“HI POWER”
▲
“ECONO”
▲
• When the following operations are conducted HIGH POWER op-
eration will be canceled.
1 When the HI POWER button is pressed again.
2 When the operation mode is changed.
3 When ECONOMY operation is conducted.
• When the following operations are conducted ECONOMY operation will be canceled.
1 When the ECONO button is pressed again.
2 When HIGH POWER operation is selected.
RKT012A754_En.p65 05.9.14, 1:43 PM9
To Next Page
Loading...
Need help?
General
