– 13 –
Remote control handling procedure
Replacing the batteries
The following cases signify exhausted batteries. Replace old batteries with new ones.
• Receiving beep is not emitted when a signal is transmitted.
• Indicator fades away.
• On the battery is printed its expected life. This may be shorter
than that of the air-conditioner, depending on the date of manu-
facture.
• However, the battery may still be in working order after expiry
of its nominal life.
NOTE
• Don't use old and new batteries together.
• Remove the batteries when the remote control is not used for a
long period.
• The life of a battery conforming to JIS or IEC is 6 to 12 months
with normal use. If used longer, or when an unspecified battery
is used, liquid may leak from the battery, causing the remote
control to malfunction.
Remove back lid and take out old batteries.
Insert new batteries. (SUM-4 or R03x2)
Close back lid.
■
When the indicator shows any abnormal condition, Press the reset
switch with the tip of a ballpoint pen.
1
2
3
Attention to
the , and .
marks
Emergency run operation
• The unit ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE : AUTO
• FAN SPEED : AUTO
• AIR FLOW : AUTO
• Operation starts by pressing the unit ON/OFF button; it stops if you press the button again.
Press the reset switch with the tip of a ballpoint pen.
4
Unit ON/OFF button
RKT012A754_En.p65 05.9.14, 1:43 PM13
To Next Page
Loading...
Need help?
General
