11
--
Mode Display
1
2
3
4
5
(5) Setting the time
3
•
5
1
•
2
•
4
Time setting display (Hour)
Time setting display (Minute)
CAUTION
Before setting the time, be sure to specify an "ON" setting at the clock ON/OFF setting item
in the user setting mode.
Stop the refrigeration unit and verify that the current time setting displays. In this condition, press the [UP]
or [DOWN] switch continuously for 3 seconds to change the display to the time setting display (Hour).
Press the [SET] switch to register the setting. The
display will change to "Minute" setting display.
Verify that the "Hour" portion of the time display is
blinking at the top of the digital display area, then
press the [UP] or [DOWN] switch to specify the
current time's "Hour" setting.
ADVICE
Each time the [UP] or [DOWN] switch is
pressed, the time value increases or
decreases by 1, respectively. If the switch
is pressed continuously, the time value
changes in a continuous manner.
ADVICE
Each time the [UP] or [DOWN] switch is
pressed, the time value increases or
decreases by 1, respectively. If the switch
is pressed continuously, the time value
changes in a continuous manner.
Verify that the "Minute" portion of the time display is
blinking at the top of the digital display area, then
press the [UP] or [DOWN] switch to specify the
current time's "Minute" setting.
Press the [SET] switch to register the setting. The
current time then displays.
To Next Page
Loading...
Need help?
General
