Combination headlamps and dipper switch
Instruments and controls 5-45
5
E00506202075
When the lamp switch is in the “ ” posi-
tion, the beam changes from high to low (or
low to high) each time the lever is pulled
fully (1). While the high-beam is on, the
high-beam indicator display in the 8 inch dig-
ital driver display will also appear.
E00506301662
The high-beams flash when the lever is
pulled slightly (2), and will go off when it is
released.
When the high-beam is on, the high-beam
indicator display in the 8 inch digital driver
display will appear.
E00528902708
This function turns on the position and tail
lamps for approximately 30 seconds after the
UNLOCK switch on the key is pressed when
the combination headlamps and dipper switch
is in the “AUTO” position. The welcome
light function will operate only when it is
dark outside the vehicle.
E00529002429
This function turns on the headlamps in the
low beam setting for approximately 30 sec-
onds after the operation mode of the power
switch is put in OFF.
1. Turn the combination headlamps and dip-
per switch to the “AUTO” position.
2. Put the operation mode of the power
switch in OFF.
3. Within 60 seconds of putting the opera-
tion mode of the power switch in OFF,
pull the turn-signal lever towards you.
If the lamp switch is in the “ ” or “ ”
position, or if the tail lamps are on when the
lamp switch is in the “AUTO” position, the
daytime running lamps come on as position
lamps.
Dipper (high/low beam change)
Headlamp flasher
If you turn the lamps off with the headlamps
set to high-beam, the headlamps are auto-
matically returned to their low-beam setting
when the lamp switch is next turned to the
“ ” position.
Welcome light
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Press the LOCK switch on the key.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Put the operation mode of the power switch
in ON.
It is possible to modify functions as follows:
• The headlamps can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact an
authorised MITSUBISHI MOTORS dealer.
Coming home light
To Next Page
Loading...
Need help?
General
