Rear-view camera
Starting and driving 6-45
6
The rear-view camera (A) is integrated into
the part near the tailgate switches.
When you put the select position in the “R”
(REVERSE) position with the operation
mode of the power switch in ON, the view
behind the vehicle will automatically appear
on the screen of the equipped audio system.
When you put the select position in any other
position, the screen will return to its original
indication.
Location of rear-view camera
Range of view of rear-view camera
How to use the rear-view cam-
era
The rear-view camera has a special lens that
can make objects shown on the screen appear
to be closer or further away than they actu-
ally are.
Because the rear-view camera has a special
lens, the lines on the ground between parking
spaces may not look parallel on the screen.
In the following situations, the screen indica-
tion may be difficult to see. There is no
abnormality.
• Low light (nighttime)
• When the light of the sun or the light from a
vehicle’s headlamps shines directly into the
lens
If the camera is hot and is then cooled by
rain or a car wash, the lens can mist up. This
phenomenon does not indicate a malfunc-
tion.
It is not possible to fully see obstacles when
the lens is dirty. If the lens becomes contami-
nated by water droplets, snow, mud, or oil,
wipe off the contamination, taking care not
to scratch the lens.
Please observe the following cautions. Ignor-
ing them could lead to a camera malfunction.
• Do not subject the camera to physical
shock.
• Do not apply wax to the camera.
• Do not splash the camera with boiling
water.
• Do not disassemble the camera.
To Next Page
Loading...
Need help?
General
