Tyre repair kit
8-10 For emergencies
8
11. After injecting the sealant, pull the hose
off the valve, remove any residual sealant
from the valve, rim and/or tyre. Fit the
valve insert (F) into the valve (D), and
screw the valve insert securely into place
using the valve remover (E).
12. After injecting the sealant, securely fit the
valve remover (E) into the end of the filler
hose (J) to prevent sealant from leaking
from the empty bottle.
13. Pull out the compressor hose (K) from the
side of the tyre compressor, and then
securely attach the hose to the tyre valve
(D).
When injecting the sealant, position the
valve away from the bottom, i.e., away from
the point where the tyre touches the ground.
If the valve is near the point where the tyre
touches the ground, the sealant may not go
into the tyre easily.
When removing and screwing in the valve
insert using the valve remover, turn the valve
remover by hand. Using a tool to turn the
valve remover could damage it.
To Next Page
Loading...
Need help?
General
