Tyre repair kit
For emergencies 8-11
8
14. Place the compressor (L) with its air pres-
sure gauge (M) on top.
Pull out the compressor’s power cord (N),
insert the plug on the cord into the acces-
sory socket (O), and then put the opera-
tion mode of the power switch in ACC.
(Refer to “Accessory socket” on page
7-11.)
Turn ON the compressor switch (P) and
inflate the tyre to the specified pressure.
(Refer to “Tyre inflation pressures” on
page 10-12.)
The supplied compressor is designed only
for inflation of your vehicle tyres.
The compressor is designed to run on a vehi-
cle’s 12 V power supply. Do not connect it to
any other power source.
The compressor is not waterproof. If you use
it in rain, make sure water does not get on it.
To Next Page
Loading...
