Electric window control
3-24 Locking and unlocking
3
However, once the driver’s door or the front
passenger’s door is opened, the windows can-
not be operated.
E00302502586
When the door window is automatically
closed by pulling up the switch fully, if a
hand or head is trapped in the closing win-
dow, it will lower automatically.
Nonetheless, make sure that nobody puts
their head or hand out of the window when
closing the driver’s door window.
The lowered window will become operational
after a few seconds.
Safety mechanism (driver’s
window only)
If the auxiliary battery terminals are dis-
connected or the fuse for electric window
is replaced, the safety mechanism will be
cancelled.
If a hand or head got trapped, a serious
injury could result.
The safety mechanism is cancelled just
before the window is fully closed. This
allows the window to close completely.
Therefore be especially careful that no fin-
gers are trapped in the window.
The safety mechanism is deactivated while
the switch is pulled up. Therefore be espe-
cially careful that fingers are not trapped in
the door window opening.
The safety mechanism can be activated if the
driving conditions or other circumstances
cause the driver’s door window to be sub-
jected to a physical shock similar to that
caused by a trapped hand or head.
If the safety mechanism is activated five or
more times in a row, the safety mechanism
will be cancelled and the door window will
not close correctly.
In such a case, the following procedure
should be implemented to rectify this situa-
tion. If the window is open, repeatedly raise
the driver’s door window switch until that
window has been fully closed. Following
this, release the switch, raise the switch once
again and hold it in this condition for at least
1 second, then release it. You should now be
able to operate in the normal fashion.
If the auxiliary battery terminals are discon-
nected or the fuse for electric window is
replaced, the safety mechanism will be can-
celled and the door window will not auto-
matically open/close completely.
If the window is open, repeatedly raise the
driver’s door window switch until the win-
dow has been fully closed. Following this,
release the switch, raise the switch once
again and hold it in this condition for at least
1 second, then release it. You should now be
able to operate the driver’s door window in
the normal fashion.
To Next Page
Loading...
Need help?
General
