Child restraint
4-22 Seat and seat belts
4
6. Latch the tether strap hook (C) of the
child restraint system to the tether anchor
bar (D) and tighten the top tether strap
hook so it is securely fastened.
7. Push and pull the child restraint system in
all directions to be sure it is secure.
Remove the child restraint system in accord-
ance with the instructions provided by the
child restraint system’s manufacturer.
E00408702217
1. Put a child restraint system on the seat in
which you wish to install it, and remove
the head restraint from the seat.
Refer to “Head restraints” on page 4-8.
2. When installing a child restraint system,
adjust seat slide to the rearmost position.
3. Route the belt through the child restraint
according to the child restraint system
manufacturer’s instructions, then insert
the latch plate into the buckle.
A: Lower anchorage
B: Connector
If your child restraint system has a support
leg, make sure that there is a support leg at
the stable position on the floor.
If your child restraint system requires the use
of a tether strap, fasten the tether strap in
accordance with step 6.
To remove
Installing a child restraint sys-
tem to a 3-point type seat belt
(with emergency locking mech-
anism)
To install
Do not remove the head restraint when
installing a booster cushion.