Mitutoyo ARK-600 - Reset and Error Handling; Test Force Not Reset Error; Unload Switch Error; Preliminary Test Force Error

5. RESET & ERRORS
5.1 Test force not reset (after power on)
Operation Value
Loading navigator
Comments
Power ON
1 D D - D
i
1 D D . D
Flashing
(from inner to
outer)
0-0 p€
'_1
Test force is
released.
Rapidly flashing
(from right to
left)
Reset end
5.2 "Unload switch" error (after power on)
Operation
Value
Loading navigator
Comments
Power ON
(
1
1
After
approx.
13sec.
1 D D . D
1
1
Flashing
av nv
II II
L..—. J k .... J
Test force is
released.
4 LEDs light up.
Z7Z7 an
Repair is necessary
notify your dealer.
_
5.3 "Preliminary test force" error (during normal operation)
Operation Value
Loading navigator Comments
After
preliminary
test force
is applied
(ascending
operation
by handle).
> 3 1 D . D
4 LEDs light up.
an DO
If this is the case,
lower the elevating
screw, change the
specimen position,
and retry.
5.4 "Test force" error (during normal operation)
Operation
Value Loading navigator
Comments
During
test force
application
DDDD
i
4 LEDs light up.
on DO
Test force is badly
applied.
Specimen is too
soft, or scale is
badly selected.