Need help?Do you have a question about the Mitutoyo ARK-600 and is the answer not in the manual?
General| Brand | Mitutoyo |
|---|---|
| Model | ARK-600 |
| Category | Blood Glucose Meter |
| Language | English |
Identifies and describes indicators and controls on the front panel of the hardness tester.
Details the power supply, fuse holder, and communication interface connectors on the rear panel.
Explains setting parameters like limits, offset, and indenter selection using specific switches.
Details how OK/NG lamps indicate the judgment result after hardness measurement.
Explains the function of the loading navigator LEDs during preliminary test force application.
Lists standard accessories such as indenters, anvils, test blocks, and cables.
Details the physical dimensions, specimen height, and mass of the hardness testing machine.
Covers steps from removing protective boards and covers to placing the tester.
Details removing covers, levers, and attaching essential components like the anvil and lamp.
Guides on leveling the tester, setting weights, and installing the indenter correctly.
Describes the automatic test force removal procedure for hardness measurement.
Details stopping handle operation, pressing start, and the automatic test force sequence.
Explains how to read the indicated value and complete the measurement process in AUTO mode.
Details the optional load duration setting for hardness testing.
Guides through applying test force, setting duration, releasing force, and reading results in DURATION mode.
Instructs on completing the measurement by turning the elevating handle counterclockwise in DURATION mode.
Describes the status and indicators when the test force is not reset after powering on the device.
Details the 'Unload switch' error state, its indicators, and when repair is needed.
Explains the 'Preliminary test force' error, its cause, and corrective actions during normal operation.
Describes the 'Test force' error, its potential causes like specimen softness, and troubleshooting steps.
Details the 'Load switch' error, its indicators, and when professional repair is required.
Covers cleaning contact surfaces, checking frame deformation, and lubrication requirements for the tester.
Lists available Rockwell hardness scales, corresponding indenters, test forces, and hardness calculation formulas.
Outlines the procedure for measuring the preliminary test force using a load measuring device.
Details the steps for calibrating the test force, including applying loads and adjusting settings.
Explains the process for calibrating the hardness indicator using a meter testing device.
Provides detailed specifications for the model, forces, display, data output, and specimen dimensions.
Lists chassis dimensions, machine mass, applicable power supply voltages, and power consumption.
Lists standard components of the hardness tester, including specifications and quantities.
Lists various optional accessories available to meet different user requirements.
Details the RS-232C interface, including connector pin assignments and communication parameters.
Explains the DIGIMATIC interface, including connector pin assignments, data format, and timing charts.
To Next Page