Mitutoyo Surftest sj-310 series - Surftest SJ-310 Optional Accessories; Adapters, Extensions, and Mounts; Workpiece Setting Attachments

9
Accessories
Setting attachments
Accessories
(Note: Not available for the transverse tracing drive unit)
Extension rod 50 mm
No.12AAA210
Support feet set
No.12AAA216
Detector side
Vertical positioning
adapter
No.12AAA219
Magnetic stand
adapter
No.12AAA217
• SJ-310/ 310R standard accessories
• Not available for the transverse
tracing drive unit.
Nosepiece for flat surface
No.12AAA217
No.12AAA218
• SJ-310/ 310R standard accessories
• Not available for the transverse
tracing drive unit.
No.12AAE644
• SJ-310S standard accessories
• Dedicated to the transverse tracing
drive unit.
No.12AAE643
• SJ-310S standard accessories
• Dedicated to the transverse
tracing drive unit.
No.12AAA210
• Not available for the transverse
tracing drive unit.
No.12BAA303
• For connecting calculation display unit and drive unit.
No.12AAA216
• SJ-310 standard
accessory
• Not attachable to
the detector side
of the transverse
tracing drive unit.
No.12AAA219
• Not available for the
transverse tracing drive unit
Nosepiece for flat surfaces
V-type adapter
Extension rod (50 mm)
Support feet set
Magnetic stand adapter
No.12AAA221 (ø 8 mm)
No.12AAA220 (ø 9.5 mm)
Nosepiece for cylindrical surfaces
Point-contact adapter
Extension cable (1 m)
Vertical positioning adapter
Height gage adapter
No.12AAA222 (9x9 mm)
No.12AAA233 (1/4inx1/2in)
Nosepiece for
cylindrical surface
No.12AAA218
Height gage adapter
72mm
7.7mm
Enhances measurement efficiency by facilitating the measurement setup of multiple workpieces of the same type and of the hard-to-access sections of a workpiece.
V-type for measuring axially Slider type
Inside diameter type
No.178- 033
The V-width is adjustable
to the cylindrical workpiece
diameter, facilitating axial
measurement of a wide range
workpiece sizes.
• Adjustable range:
ø 5 ~ 150 mm
No.178- 035
Greatly facilitates measurement of
internal wall surfaces of, for
example, a cylinder block.
• Applicable diameter:
ø 75 ~ ø 95 mm
• Accessible depth:
30 ~ 135 mm
No.178- 034
This attachment is ideal for measuring a
flat area of a workpiece that has an
indentation or step that makes it difficult
to attach the drive unit. You can further
improve the ease of use by using this
attachment with the magnetic
installation base (option: No.12AAA910).