What to do if Mitutoyo SURFTEST SJ-410 Test Equipment SJ-410 cannot be turned on with AC adapter?
If your Mitutoyo Test Equipment (SJ-410) fails to power on with the AC adapter, first, ensure the AC adapter is correctly and securely connected. If the issue persists, verify that you are using only the AC adapter supplied with the device. If problems continue, there may be internal damage.
Why my Mitutoyo Test Equipment SJ-410 cannot be turned on when powered by the battery?
If your Mitutoyo Test Equipment (SJ-410) does not turn on when powered by the battery, it could be due to a low battery. Recharge the battery. Alternatively, the battery switch may be set to OFF. In this case, set the battery switch to ON.
Limited error after reading
General| Data Storage | Internal memory, USB flash drive |
|---|---|
| X-Axis Resolution | 0.1 µm |
| Stylus Tip Material | Diamond |
| Output Interface | USB, RS-232C |
| Display | color LCD |
| Power Supply | AC adapter (100-240 V) |
| X-Axis Measuring Range | 25 mm |
| Measuring Force | 4 mN (0.4 gf) |
| Traverse Speed | 0.5 mm/s |
| Stylus Tip Radius | 2 µm |
| Detector Type | Differential inductance method |
| Analysis Parameters | Ra, Rq, Rz, Rt, Rp, Rv, Rc, Rsk, Rku, RSm, Rmr |
| Measuring Speed | 0.5 mm/s |
To Next Page
