Mitutoyo SURFTEST SJ-410 - Analyzing the Coordinate Difference

16. DISPLAYING AND ANALYZING THE EVALUATION PROFILES AND GRAPHS
No. 99MBB765A
16-7
Evaluation Profile screen
 The evaluation profile is scrolled.
TIP
• Display can also be scrolled vertically/h
orizontally by
touching the scroll bar area using the touch pen.
16.2.2 Analyzing the coordinate difference
You can specify two X-coordinate points of the evaluation profile to display the coordinate
difference between them.
The coordinate difference is the point where the evaluation profile and ruler 2 intersect
(P2) minus the point where the evaluation profile and ruler 1 intersect (P1).
There are 2 ways of specifying the X-coordinate: touching the evaluation profile and
entering the coordinate values.
IMPORTANT
• When performing coordinate difference analysis, the screen will be displayed with
"Del.Wave" set to "OFF".
■ Specifying by touching the evaluation profile (Refer to 16.1 "■ Accessing the Analyze Waveform screen".)
Home screen ⇒ [Evaluation Profile] ⇒ [Analyze Waveform]
Analyze Waveform screen
1
Touch .
NOTE
• When R-Motif or W-Motif is selected for a profile motif,
the coordinate difference cannot be analyzed.
Analyze Coordinate Difference screen
 The rulers are displayed on the Analyze Coordinate Difference
screen.
The blue one is Ruler 1, the red one is Ruler 2.
When the X-coordinate is specified for the first time, ruler 1 is
selected.
(blue) is displayed on the selected ruler.