■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒ ⇒
Measurement Conditions Menu screen
1 Touch on the Measurement Condition Menu
screen.
Touching
cycles through the available settings,
ON and OFF.
7.5.8 Setting the retraction
By using the automatic positioning unit (optional accessory), it can be set whether to
transfer the detector to the retraction position after the measurement is performed.
Retraction
Retraction operation
TIP
• Retraction can also be set in the Drive Unit Operation screen. For information about
setting the retraction in the Drive Unit Operation screen, refer to "5.5.2 Measurement
using the automatic positioning unit" (page 5-13).
■ Operating procedure (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒
Measurement Conditions Menu screen
1 Touch on the Measurement Condition Menu
screen.
Touching
cycles through the available settings,
ON and OFF.
No. 99MBB765A
7-56
To Next Page
Loading...
