Mitutoyo SURFTEST SJ-410 - Selecting Parameters

No. 99MBB765A
18-4
18.1.1 Selecting parameters
Select the parameters for SPC output.
Only the calculation results of parameters displayed on the Home screen with the SPC
mark (
) can be output as SPC data.
1 Press [Switch Parameter] key of the SJ-410 until the objective parameter
for output is displayed.
Parameter display
2 When the parameters are displayed in the four columns, touch the parameter to be
output to move the SPC mark.
Parameter selection (4 columns displayed on 1 screen)
[Parameter switching]
Customized parameters
are displayed in turn.